Sgtype -- Set Type Of Signal Produced By Signal Generator; Soundl -- Play Sound Locally - Polycom Vortex EF2211 Programming Manual

S01SGMUTE2 Toggle mute on signal generator.
S01SGMUTE? Query signal generator mute.
8.143. SGTYPE -- Set Type of Signal Produced by Signal
Generator
This command sets the type of signal produced by the internal signal generator. Setting the type to 0
produces white noise, while setting the type to 1 produces pink noise.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Configure signal generator to produce
S01SGTYPE0
white noise.
Configure signal generator to produce
S01SGTYPE1
pink noise.
S01SGTYPE? Query current signal generator type.

8.144. SOUNDL -- Play Sound Locally

This command can be used to play sounds from the telephone interface to serve as audio cues. The
command plays sounds out to the phone output. The SOUNDL command plays sounds
SOUNDP
through the input from the telephone interface (so they will be heard locally). The same sound
generator is also used for playing entry and exit tones for the auto answer and auto hangup features.
This command takes a single argument that indicates the sound to be played. The following table lists
the sound numbers and a description of the generated sound.
Sound Number
0
1
2
3
4
5
S01SGMUTEx , where x is 0 or 1 depending on the
current state of the signal generator mute.
S01SGMUTEx , where x is 0 or 1 depending on the
current state of the signal generator mute.
Status Message
S01SGTYPE0
S01SGTYPE1
S01SGTYPEx , where x is either 0 or 1
depending on whether the signal generator
is currently configured to generate white or
pink noise, respectively.
Sound Description
ascending thirds
descending thirds
ascending chorus
descending chorus
ascending doorbell
descending doorbell