Gaindit -- Set Gain Of Incoming Dtmf Tones; Gaindt -- Set Dial Tone Gain - Polycom Vortex EF2211 Programming Manual

This command is an integer command. See
command. The minimum and maximum values for this command are -20 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
S01GAIND6 Set incoming DTMF gain to 6 dB.
S01GAIND>3 Increase incoming DTMF gain by 3 dB.
S01GAIND? Query incoming DTMF gain.

8.55. GAINDIT -- Set Gain of Incoming DTMF Tones

This command sets the gain of the incoming DTMF tones. The gain of the outgoing DTMF depends on
the country that the Vortex is configured for (see the COUNTRY) command.
This command is an integer command. See
command. The minimum and maximum values for this command are -20 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
S01GAINDIT6 Set incoming DTMF tone gain to 6 dB. S01GAINDIT6
Increase incoming DTMF tone gain by
S01GAINDIT>3
3 dB.
S01GAINDIT? Query incoming DTMF tone gain.

8.56. GAINDT -- Set Dial Tone Gain

Section 6.2 for more information on this type of
Status Message
S01GAIND6
S01GAINDx , where x is the new value of the
incoming DTMF gain. If this command was
issued after the example above, then the
status message would be S01GAIND9 .
S01GAINDx , where x is the new value of the
incoming DTMF gain. If this command was
issued after the example above, then the
status message would be S01GAIND9 .
Section 6.2 for more information on this type of
Status Message
S01GAINDITx , where x is the new value
of the incoming DTMF tone gain. If this
command was issued after the example
above, then the status message would be
S01GAINDIT9 .
S01GAINDITx , where x is the new value
of the incoming DTMF tone gain. If this
command was issued after the example
above, then the status message would be
S01GAINDIT9 .