Polycom Vortex EF2211 Programming Manual page 123

Query status of VTX mode on
S01VTXMODOA?
output A.
Enable VTX mode on outputs 1,
S01VTXMODO*1
A-B.
Disable VTX mode on outputs 1,
S01VTXMODO*0
A-B.
Enable VTX mode on output 1
and disable VTX mode on
S01VTXMODO*100
output A-B.
Toggle status of VTX mode on
S01VTXMODO*2
outputs 1, A-B.
Query status of VTX mode on
S01VTXMODO*?
outputs 1, A-B.
S01VTXMODOAx , where x is either 0 or 1
depending on the current status of VTX mode
on output A.
S01VTXMODO*111
S01VTXMODO*000
S01VTXMODO*100
S01VTXMODO*abc , where each of the letters
(a, b, etc.) is either 0 or 1 depending of the
current status VTX mode on the corresponding
output. If this command was sent after the
example above, then the status message
would be S01VTXMODO*011 .
S01VTXMODO*abc , where each of the letters
(a, b, etc.) is either 0 or 1 depending of the
current status VTX mode on the corresponding
output. If this command was sent after the
example above, then the status message
would be S01VTXMODO*011 .