Flash -- Execute Hook Flash; Flow -- Set Flow Control Mode For Rs-232 Port - Polycom Vortex EF2211 Programming Manual

S01FADERIA?
S01FADERI*6
S01FADERI*ìääì
S01FADERI*?

8.49. FLASH -- Execute Hook Flash

This command puts the phone on-hook and then takes it back off-hook after a delay. The amount of
time between on-hook and off-hook is controlled by the
country to meet each country's specific compliance requirements. If the phone is on-hook when this
command is given, then no action is performed.
Example Description
S01FLASH Execute hook flash.

8.50. FLOW -- Set Flow Control Mode for RS-232 Port

This command sets the flow control mode for the rear panel RS-232 port. The valid settings are:
Command Value
0
1
2
Query the fader gain on input
A.
Set fader gain on all inputs (1,
A, B, T) to 6 dB.
Set fader gain on input
channels A and B to 0 dB and
gain on input channels 1 and T
to 9 dB.
Query fader gain on all inputs
(1, A, B, T) .
Status Message
If the phone is on-hook, no action is performed, and the response
will be
S01FLASH
If the phone is off-hook, the response will be
S01FLASH
S01PHONE0
S01PHONE1
The PHONE status messagges occur when the phone goes on-hook
and back off-hook.
Description
No flow control.
Hardware flow control.
Auto-detect hardware flow control or no flow control.
S01FADERIAx , where x is a number between
0 and 30, depending on the current setting of
the fader gain on input channel A.
S01FADERI*èèèè
S01FADERI*ìääì
S01FADERI*abcd, where a-d are each
between ä and ÿ, depending on the current
setting of the fader gains for each of the four
input channels.
setting and has be set for each
COUNTRY