Peqoa -- Set All Parameters For Specified Parametric Eq Output Stage - Polycom Vortex EF2211 Programming Manual

parameter, the filter type, is specified instead of all the parameters. See the
more information. To set the slope parameter for an output parametric EQ filter, use the
command. To set all the parameters for an output parametric EQ filter, use the
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Set the type of the parametric EQ
S01PEQIT1,2,1
on input 1 , band 2 to parametric.
Query current type setting of
parametric EQ on input B , band
S01PEQITB,1,?
1.
8.121. PEQOA -- Set All Parameters for Specified Parametric
EQ Output Stage
This command sets or queries all of the parameters for the parametric equalizer (EQ) filters on output
channels 1, A, B, and T output channel T. Each channel has five bands of parametric EQ that can be
independently controlled.
The output parametric EQ filter parameters can be set individually via the PEQOT, PEQOF, PEQOB,
PEQOG, PEQOS, and
simultaneously via the
PEQIS, and commands.
PEQIE
When using this command, you must specify all of the following parameters.
Description Value Range
Channel 1, A, B, T
Band 1-5
Filter Type 1-5
Frequency 20 - 20000
Bandwidth 5 - 200
commands. The input parametric EQ filter parameters can be set
PEQOE
command or individually with the PEQIT, PEQIF, PEQIB, PEQIG,
PEQIA
Status Message
S01PEQIT1,2,1
S01PEQITB,1,t , where t is the current
setting of the type parameter for the
parametric EQ on input B , band 1. If the type
parameter of this filter is set to the same
value given in the example above, then the
status message will be S01PEQITB,1,1 .
Units
N/A
N/A
1 = parametric filter
2 = low shelf
3 = high shelf
4 = lowpass
5 = highpass
6 = Linkwitz-Riley lowpass
7 = Linkwitz-Riley highpass
Hz
1/100th octave
command for
PEQIA
PEQOT
command.
PEQOA