Cgatet -- Set Camera Gating Hold Time - Polycom Vortex EF2211 Programming Manual

This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Disable automatic camera gating
S01CGATEEN0
messages.
Enable automatic camera gating
S01CGATEEN1
messages.
Toggle enabled state of automatic
S01CGATEEN2
camera gating messages.
Query enabled state of automatic
S01CGATEEN?
camera gating messages.

8.39. CGATET -- Set Camera Gating Hold Time

This command sets the hold time (in milliseconds) for the camera gating (CGATE) feature.
This command is an integer command. See
command. The minimum and maximum values for this command are 100 and 5000, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Set camera gating hold time to
S01CGATET500
500 ms.
Increase camera gating hold time
S01CGATET>500
by 500 ms.
Query camera gating hold.
S01CGATET?
Status Message
S01CGATEEN0
S01CGATEEN1
S01CGATEENx , where x is either 0 or 1
depending on whether automatic camera
gating messages are currently disabled or
enabled.
S01CGATEENx , where x is either 0 or 1
depending on whether automatic camera
gating messages are currently disabled or
enabled.
Section 6.2 for more information on this type of
Status Message
S01CGATET500
S01CGATETx , where x is between 100 and
5000 depending on the current setting of
CGATET. If this command is issued after the
example above, the status message will be
S01CGATET1000 .
S01CGATETx , where x is between 100 and
5000 depending on the current setting of
CGATET. If this command is issued after the
example above, the status message will be
S01CGATET1000 .