Polycom Vortex EF2211 Programming Manual page 51

This error occurs as the result of an
command attempts to set a "last mic on" number that does not belong to the
ERROR#043
specified automixer while "last mic on" mode is set to manual.
This error occurs as the result of an
command tries to enable chairman mode, but the chairman microphone is set to a
ERROR#044
microphone that does not belong to the specified automixer.
This error occurs as the result of an
command tries to set the chairman microphone to a microphone that does not
ERROR#045
belong to the specified automixer while chairman mode is enabled.
This error occurs when the user has attempted to utilize more variable DSP
resources than are available. This may occur if too many matrix crosspoints are
ERROR#060
unmuted or too many parametric EQ filters are enabled. The
can query the current percentage utilization of DSP resources.
This error occurs as a result of a macro or preset execution command (PRESETX,
PRESETQ, MACROX, MACROQ). It indicates that the macro or preset requested was
ERROR#070
empty.
This error occurs as a result of a
PRESETW
ERROR#071
is not allowed. In the case of PRESETK, it indicates that an attempt was made to
delete a factory preset, which is not allowed.
This error occurs as a result of a
ERROR#072
commands in the preset had errors during execution.
This error occurs as a result of a
ERROR#073
many commands in the macro. The limit is 256 commands per macro.
This error occurs in response to a
ERROR#074
If the command written to the macro or logic pin is illegal, then this error occurs.
This error occurs when a command attempts to write non-volatile memory, but non-
ERROR#075
volatile memory is password protected via NVLOCK.
This error occurs when attempting to add a macro command (either during an
upload or while writing a single macro) and the Vortex runs out of room in non-
volatile memory. As a result, the entire macro is discarded. If this occurs during an
ERROR#076
upload, all previous macros (before the one that caused the error) are written
successfully.
This error occurs when attempting to add a command to a macro, but the Vortex is
not in the process of writing a macro. This may happen if you forget to do a
ERROR#077
MACROS or UMACROS command, or if you had an ERROR#076 and continued trying
to add commands.
This error indicates an EF Bus hardware handshaking error. This could happen if
bussed units are not powered on simultaneously. Powering the units up
ERROR#090
simultaneously should remove the error.
This error indicates an EF Bus software handshaking error. This could happen if
bussed units are not powered on simultaneously. Powering the units up
ERROR#091
simultaneously should remove the error.
it indicates that an attempt was made to write to a factory preset, which
command. It happens when the
AMLMN
command. It happens when the
AMCHAIR
command. It happens when the
AMCHAIR
or
PRESETW PRESETK
command. It indicates that one or more
PRESETQ
command when there are already too
MACROA
or a logic pin (LIA, LIH, etc.) command.
MACROA
command
DSPLOAD
command. In the case of