Amasgn -- Assign Inputs To An Automixer - Polycom Vortex EF2211 Programming Manual

off-hook or busy tones and hangs up the phone if they are detected. The loop drop method looks for
a drop in loop current on the phone line and hangs up the phone if a loop current drop is detected.
The command controls the call progress auto hangup feature. The AHLD command controls the
AHCP
loop drop auto hangup feature. These two features are controlled and implemented independently.
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
S01AHLD1 Enable loop drop based auto hangup mode. S01AHLD1
S01AHLD0 Disable loop drop based auto hangup mode. S01AHLD0
S01AHLD2 Toggle loop drop based auto hangup mode.
S01AHLD? Query auto hangup mode.

8.11. AMASGN -- Assign Inputs to an Automixer

This command is used to assign the mic/line inputs (1) to an internal automixers. Setting AMASGN to 0
for a given input channel corresponds to no automixer, and 1 corresponds to Automixer #1 .
Although this command is a channel integer command, the increment and decrement operators (>
and <) are not supported for this particular command.
This command is a channel integer command. See
on this type of command. The minimum and maximum values for this command are 0 and 2,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
S01AMASGN11 Assign input 1 to automixer #1.
Query current automixer assignment
S01AMASGN1?
for channel 1.
Section 6.1 for more information on this type of command.
Status Message
S01AHLDx , where x is 0 or 1 depending
on the current state of the loop drop based
auto hangup mode.
S01AHLDx , where x is 0 or 1 depending
on the current state of the loop drop based
auto hangup mode.
Section 6.3 and
Status Message
S01AMASGN11
S01AMASGN1x , where x is 0, 1, or 2
depending on the current automixer
assignment for channel 1. If this command
is issued after the example above, then the
status message will be S01AMASGN11 .
Section 6.2 for more information