Dspload -- Query Percentage Of Variable Dsp Resources Used; Error -- Enable Or Disable Error Messages - Polycom Vortex EF2211 Programming Manual

Query the value of the DSPAUTO
S01DSPAUTO?
parameter.
8.45. DSPLOAD -- Query Percentage of Variable DSP
Resources Used
This command queries the current percentage used of the available variable DSP resources. When this
number reaches 100 percent, no more variable DSP veatures may ben enabled. An 'ERROR#060' will
be generated if a command attempts to exceend 100 percent utilization.
If the feature is enabled, then a DSPLOAD status message will be generated automatically
DSPAUTO
any time the percent utilization changes.
Example Description
Query percentage of variable DSP
S01DSPLOAD?
resources used.

8.46. ERROR -- Enable or Disable Error Messages

This command sets or queries whether or not error messages for non-fatal errors are reported via RS-
232 and the digital bus.
If an error is generated and error messages are enabled, a status message will be automatically
generated of the form ' S01ERROR#xxx ', where xxx is a three digit number indicating the error
code. The following table lists the non-fatal error messages that can be generated by the Vortex.
Error Number Description
Unrecognized command.
ERROR#001
Syntax error in command.
ERROR#002
Attempt to change parameter that is locked via
ERROR#004
Attempt to unlock
ERROR#005
This error occurs as the result of an
command would remove a microphone from an automixer where it is assigned as
ERROR#040
the "last mic on" and the automixer is set to manual "last mic on" mode.
This error occurs as the result of an
command would remove a microphone from an automixer where it assigned as the
ERROR#041
chairman imcrophone and the automixer has chairman mode enabled.
This error occurs as the result of an
command attempts to set "last mic on" mode to manual, but the last mic number is
ERROR#042
set to a microphone that does not belong to the specified automixer.
or FPLOCK, but invalid password given.
NVLOCK
AMASGN
AMASGN
AMLMM
S01DSPAUTOx , where x is 0 or 1
depending on the current setting of the
DSPAUTO paramter.
Status Message
S01DSPLOADx , where x is between 0 and
99 and indicates the percentage of the
variable DSP resources being used.
or FPLOCK.
NVLOCK
command. It happens when the
command. It happens when the
command. It happens when the