Ssen -- Enable Or Disable Screen Saver; Ssstart -- Set Idle Time Required For Screen Saver To Start - Polycom Vortex EF2211 Programming Manual

This command sets or queries the amount of time (in milliseconds) between each new screen of the
LCD screen saver.
This command is an integer command. See
command. The minimum and maximum values for this command are 500 and 600000, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example
S01SSDELAY2000
S01SSDELAY>500
S01SSDELAY?

8.147. SSEN -- Enable or Disable Screen Saver

This command controls whether or not the LCD screen saver is enabled.
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
S01SSEN1 Enable screen saver.
S01SSEN0 Disable screen saver.
S01SSEN2 Toggle screen saver enabled state.
S01SSEN? Query screen saver enabled state.
8.148. SSSTART -- Set Idle Time Required for Screen Saver
to Start
Description
Set screen saver delay to 2
seconds (2000 ms).
Increase screen saver delay by
0.5 seconds (500 ms).
Query screen saver delay.
Section 6.2 for more information on this type of
Status Message
S01SSDELAY2000
S01SSDELAYx , where x is the new value of
the screen saver delay. If this command was
issued after the example above, then the
status message would be S01SSDELAY2500 .
S01SSDELAYx , where x is the new value of
the screen saver delay. If this command was
issued after the example above, then the
status message would be S01SSDELAY2500 .
Section 6.1 for more information on this type of command.
Status Message
S01SSEN1
S01SSEN0
S01SSENx , where x is 0 or 1 depending on the
current enabled state of the scrren saver.
S01SSENx , where x is 0 or 1 depending on the
current enabled state of the scrren saver.