Gateen -- Enable Automatic Gating Messages; Gmuteo -- Mute All Outputs - Polycom Vortex EF2211 Programming Manual

status of all the microphone inputs. On the EF2211 and EF2210, there is only one microphone, so the
wildcard character is of limited use.
The can be used to have gating information sent automatically instead of having to poll this
GATEEN
command.
Also see the
CGATE
specified hold time.
Example Description
S01GATE1? Query gating status of microphone input 1.

8.64. GATEEN -- Enable Automatic Gating Messages

This command controls whether or not gating information messages are sent automatically. If
GATEEN is enabled, then a GATE*? query is performed each time the gating status of any microphone
changes. For example, if no microphones are currently gated on and GATEEN is enabled, then if
microphone input 1 gates on, the following status message will be automatically generated:
S01GATE*1
See the command for more information.
GATE
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
S01GATEEN0 Disable automatic gating messages.
S01GATEEN1 Enable automatic gating messages.
Toggle enabled state of automatic gating
S01GATEEN2
messages.
Query enabled state of automatic gating
S01GATEEN?
messages.

8.65. GMUTEO -- Mute All Outputs

command, which only reports microphones that have been gated on for a
Status Message
S01GATE1? , where x is 0 or 1 depending
on whether the input is gated off or gated
on, respectively.
Section 6.1 for more information on this type of command.
Status Message
S01GATEEN0
S01GATEEN1
S01GATEENx , where x is either 0 or 1
depending on whether automatic gating
messages are currently disabled or
enabled.
S01GATEENx , where x is either 0 or 1
depending on whether automatic gating
messages are currently disabled or
enabled.