Swreset -- Perform Soft Reset Of System; Swver -- Query Software Version; Tonee -- Enable Or Disable Entry And Exit Tones - Polycom Vortex EF2211 Programming Manual

S01SSTEXT0,1,?

8.150. SWRESET -- Perform Soft Reset of System

Executing this command causes the Vortex to perform a software reset. The effect of the software
reset is similar to cycling the power.
Example Description
S01SWRESET Perform a software reset.

8.151. SWVER -- Query Software Version

This command is used to query the firmware version of the Vortex.
Example Description
S01SWVER? Query current software version.

8.152. TONEE -- Enable or Disable Entry and Exit Tones

This command sets or queries the enabled status of the entry and exit tone feature. If entry and exit
tones are enabled, a specific tone is played whenever the auto-answer feature takes the phone off-
hook. A different tone is played whenever the auto-hangup feature puts the phone on-hook. This
feature is typically enabled to prevent a caller from entering or exiting a conference unannounced.
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
S01TONEE1 Enable auto entry and exit tones.
S01TONEE0 Disable entry and exit tones.
Query the text of
the second line of
the first screen.
Status Message
No status message will be received. The Vortex will reset
within a few seconds.
Status Message
S01SWVER<string> , where <string> is the
current sofware version. If the software version was
2.5.0, then the status message would be
S01SWVER2.5.0 .
Section 6.1
S01SSTEXT0,1,<string> , where
<string> is the text of the second line of
the first screen. If this command was issued
after the example above, then the status
message would be S01SSTEXT0,1,funky
music .
for more information on this type of command.
Status Message
S01TONEE1
S01TONEE0