Gainsot -- Set To Phone User Tone Gain; Gate -- Query Gating Status Information - Polycom Vortex EF2211 Programming Manual

will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
S01GAINSIT6 Set tone output gain to 6 dB.
S01GAINSIT>3 Increase tone output gain by 3 dB.
S01GAINSIT? Query tone output gain.

8.62. GAINSOT -- Set To Phone User Tone Gain

This command sets the gain of the user tones coming from the phone DSP. User tones include entry
and exit tones (see TONEE) and custom tones (see the
cases, the tones are played out "locally" and their gains are adjusted by the
Sometimes, the tones are played out to the phone, and the gain is adjusted by the GAINSOT
command.
This command is an integer command. See
command. The minimum and maximum values for this command are -20 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
S01GAINSOT6 Set tone output gain to 6 dB.
S01GAINSOT>3 Increase tone output gain by 3 dB.
S01GAINSOT? Query tone output gain.

8.63. GATE -- Query Gating Status Information

This command is used to query the gating status of the microphone inputs. The command can be
used to query the status of individual microphones, or the wildcard character can be used to query the
Status Message
S01GAINSIT6
S01GAINSITx where x is the new value of the
tone output gain. If this command was issued
after the example above, then the status
message would be S01GAINSIT9 .
S01GAINSITx , where x is the new value of
the tone output gain. If this command was
issued after the example above, then the status
message would be S01GAINSIT9 .
SOUNDP
Section 6.2 for more information on this type of
Status Message
S01GAINSOT6
S01GAINSOTx , where x is the new value of
the tone output gain. If this command was
issued after the example above, then the status
message would be S01GAINSOT9 .
S01GAINSOTx , where x is the new value of
the tone output gain. If this command was
issued after the example above, then the status
message would be S01GAINSOT9 .
and commands). In most
SOUNDL
GAINSIT
command.