Phantom -- Enable Phantom Power On Input; Phone -- Take Phone On-Hook Or Off-Hook - Polycom Vortex EF2211 Programming Manual

Query current type setting of
parametric EQ on output B , band
S01PEQOT1,2,1
1.

8.128. PHANTOM -- Enable Phantom Power on Input 1

This command sets or queries the status of phantom power on microphone input 1.
This command is a channel boolean command. See
on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Enable phantom power for input
S01PHANTOM11
channel 1.
Disable phantom power for input
S01PHANTOM10
channel 1.
Toggle phantom power state for
S01PHANTOM12
input channel 1.
Query state of phantom power for
S01PHANTOM1?
input channel 1.

8.129. PHONE -- Take Phone On-Hook or Off-Hook

This command sets or queries the on-hook status of the phone interface.
This command is a boolean command. See
Example Description
Put phone interface on-hook (hang up
S01PHONE0
phone interface).
Take phone interface off-hook (pick up
S01PHONE1
phone interface).
S01PEQOTB,1,t , where t is the current
setting of the type parameter for the
parametric EQ on output B , band 1. If the
type parameter of this filter is set to the same
value given in the example above, then the
status message will be S01PEQOTB,1,1 .
Section 6.3
Status Message
S01PHANTOM11
S01PHANTOM10
S01PHANTOM1x , where x is 0 or 1
depending on the current state of phantom
power on input channel 1.
S01PHANTOM1x , where x is 0 or 1
depending on the current state of phantom
power on input channel 1.
Section 6.1 for more information on this type of command.
Status Message
S01PHONE0
S01PHONE1
and Section 6.1 for more information