Sggain -- Set Gain Of Signal Generator; Sgmute -- Mute Signal Generator - Polycom Vortex EF2211 Programming Manual

S01RING1 Enable auto answer mode. S01RING1
S01RING0 Disable auto answer mode. S01RING0
S01RING2 Toggle auto answer mode.
S01RING? Query auto answer mode.

8.141. SGGAIN -- Set Gain of Signal Generator

This command sets the gain of the internal signal generator. The value of SGGAIN specifies the gain
in dB applied to signal generator. A gain of 0 dB produces a signal at nominal level (-20 dB full scale).
This command is an integer command. See
command. The minimum and maximum values for this command are -100 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
S01SGGAIN6 Set signal generator gain to 6 dB.
S01SGGAIN>3 Increase signal generator gain by 3 dB.
S01SGGAIN? Query signal generator gain.

8.142. SGMUTE -- Mute Signal Generator

This command controls the muting of the signal generator.
This command is a boolean command. See
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
S01SGMUTE1 Mute signal generator.
S01SGMUTE0 Unmute signal generator.
S01RINGx , where x is 0 or 1 depending on the current
state of auto answer mode.
S01RINGx , where x is 0 or 1 depending on the current
state of auto answer mode.
Section 6.2 for more information on this type of
Status Message
S01SGGAIN6
S01SGGAINx , where x is the new value of
the signal generator gain. If this command
was issued after the example above, then
the status message would be S01SGGAIN9 .
S01SGGAINx , where x is the new value of
the signal generator gain. If this command
was issued after the example above, then
the status message would be S01SGGAIN9 .
Section 6.1 for more information on this type of command.
Status Message
S01SGMUTE1
S01SGMUTE0