Disassembling The Engine; Clamping The Engine Into The Engine Assembly Stand; Draining The Engine Oil - KTM 2014 690 SMC R EU Repair Manual

16 ENGINE
16.3

Disassembling the engine

16.3.1

Clamping the engine into the engine assembly stand

16.3.2

Draining the engine oil

–
Remove the oil filler plug
engine oil.
Engine oil
–
Mount and tighten the filler plug with O-ring
G00910-10
Finishing work
–
Fill/bleed the cooling system. (
–
Install the air filter box. (
–
Mount the side cover. (
–
Mount the seat. (
–
Remove the motorcycle from the work stand. (
–
Perform the initialization run. (
–
Take a short test ride.
–
Read out the fault memory using the KTM diagnostics tool.
–
Check the engine for leakage.
–
Check the engine oil level. (
–
Check the coolant level. (
–
Mount special tool
Engine assembly stand (61229001000) (
Support for engine assembly stand (75012001060) (
Holder for engine assembly stand (75012001070) (
–
Mount the engine on special tool
Info
Have an assistant help you or use a crane.
305506-10
–
Remove the oil drain plug
–
Remove plug
305508-10
–
Remove plug
–
Completely drain the engine oil.
305509-10

with the O-ring from the clutch cover and fill up with
1.70 l (1.8 qt.)
p. 178)
p. 59)
p. 62)
p. 62)
p. 189)
p. 181)
p. 180)

on engine assembly stand

.

with the magnet and seal ring.
 with oil screen and the O-rings.
 
with oil screen and the O-rings.
Engine oil (SAE 10W/60)
(00062010035) ( p. 224)
Alternative engine Engine oil
oil (SAE 10W/50)
( p. 224)

.
p. 12)

.
p. 232)
p. 232)
p. 232)
111