Replacing Assemblies - Agilent Technologies 16962A Service Manual

Agilent 16962A Logic Analyzer
Service Guide
6

Replacing Assemblies

To remove the module
To remove the logic analyzer cable
To install the logic analyzer cable
To replace the circuit board
To return assemblies
This chapter contains the instructions for removing and
replacing the logic analyzer module, the circuit board of the
module, and the probe cables of the module as well as the
instructions for returning assemblies.
Turn off the instrument before installing, removing, or replacing a
C A U T I O N
module in the instrument.
Electrostatic discharge can damage electronic components. Use
C A U T I O N
grounded wriststraps and mats when performing any service to this
module.
Tools Required
• A T10 TORX screwdriver is required to remove screws
connecting the probe cables and screws connecting the back
panel.
82
82
84
86
87
Agilent Technologies
81