Agilent Technologies 16962A Service Manual page 73

5
Troubleshooting
72
connector
Set up the stimulus board
2
Configure the oscillator select switch S1 according to
a
the following settings:
• S1 0 (Off).
• S2 1 (On).
• S3 0 (Off).
• Int.
Configure the data mode switch S4 according to the
b
following settings:
• Even.
• Count.
c Press the Resynch VCO button, then the Counter RST
(Counter Reset) button.
In the Agilent Logic Analyzer application, choose
3
FileNew. This puts the logic analysis system into its
initial state.
Pod 1
Pod 4
Pod 5
connector
16962A Logic Analyzer Service Guide
Pod 2