Table of Contents
Advertisement
C A U T I O N
16962A Logic Analyzer Service Guide
gently apply pressure to seat the logic analyzer cable
onto the circuit board connector.
c
Insert the top and bottom logic analyzer cable clamps
into the rear panel.
2
Secure the cable clamp to the rear panel.
a
Install the four screws (H5) vertically through the cable
clamp into both the cable clamp and the circuit board.
Tighten the cable clamp screws (H5) to 5 in/lb.
b
If you over tighten the screws, the threaded inserts on the rear
panel, the threaded inserts on the circuit board, or the cable clamp
itself might break. Tighten the screws only enough to hold the cable
in place, approximately 5 in/lb.
Replacing Assemblies
H4
85
6
Advertisement
Table of Contents
