Huawei UPS5000-S-400K-SM User Manual page 251

UPS5000-S-(350 kVA-800 kVA)
User Manual
Figure 5-1 Settings Wizard
Step 2 After you set parameters on the Settings Wizard screen, the system displays the
Bypass mode and No battery alarms, which do not need to be handled. If there is
any other alarm, you need to rectify the fault.
Issue 12 (2023-05-26)
NO TE
● Set the time and date correctly. Incorrect time and date will cause false fault analysis
during maintenance or repair.
● After you set network parameters, connect the UPS to the network over a network
cable, which enables you to remotely manage the UPS. If you do not need remote
management, retain the default network parameter settings.
NO TE
● After you set parameters on the Settings Wizard screen, choose System Info > Settings
> System Setting. Check that System Capacity, Power module capacity, Requisite
modules, and Redundant modules match the actual values.
● If dry contact signals are connected to the system, choose System Info > Settings > Dry
contacts Set and check that the connected dry contacts have been enabled and that the
disconnected dry contacts have been disabled.
Copyright © Huawei Digital Power Technologies Co., Ltd.
5 Operations
242