Chapter 8 Settings Backup/Restoration
Saving Settings
1
Insert a 1 GB or larger USB drive (not included) into a USB port on the TeraStation.
Note: All data on the USB drive will be erased!
2
From Settings, click Management.
3
Click the settings icon (
4
Select "Save current configuration to a USB drive".
5
From "Target USB Drive", select the USB drive that is connected to the USB port on the TeraStation, then click
Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
7
The process is complete once you close the confirmation window that appears.
Troubleshooting:
If the settings are not saved to the USB drive successfully, you may receive an error message such as "The specified
operation cannot be executed. " . Verify:
• The USB drive has a capacity of 1 GB or more.
• The USB drive is not write-protected.
• Failover is configured on the TeraStation.
Applying Settings
The saved settings can be applied to a different Buffalo NAS device of the same series. If applying settings to
another Buffalo NAS device, the unit's current firmware version will be changed to the version used to save the
settings.
1
Insert the USB drive with the saved settings into a USB port on the TeraStation.
) to the right of "Configuration Management".
222