Buffalo TeraStation 5020 User Manual page 129

Chapter 5 Backup
Code Description
The backup destination shared
folder could not be found.
Code 5
Authentication failed.
A registered user does not
have permission to run.
The Ethernet cable was
disconnected from the backup
source TeraStation when the
backup job started.
Code 10
A backup destination doesn't
support the subfolders' access
restrictions.
The drive capacity of the
backup destination TeraStation
became full.
Code 11
Files larger than 4 GB were
backed up to the FAT32-
formatted USB drive.
Could not communicate
between backup source and
destination TeraStations.
Code 12
The settings of the TeraStation
were changed while the
backup job was running.
Code 14
There was insufficient memory
on the TeraStation so the
backup job did not run.
Code 22
The connection was
Code 20 disconnected while the
backup job was running.
Corrective Action
Check that the Ethernet cable is
securely connected and that the hub
or other devices on the network are
turned on.
Try adding the rsync-compatible NAS
device from the server list again.
Check the settings of the rsync-
compatible NAS device.
Reconnect the Ethernet cable.
Select another backup destination
or remove the subfolders' access
restrictions.
Delete unnecessary files and folders.
Reduce the file size to 4 GB or less, or
change the file system to one other
than FAT32. Refer to the "Adding an
External Drive" section in chapter 4 for
compatible file systems.
Check that the Ethernet cable is
securely connected and that the hub
or other devices on the network are
turned on.
Do not change the settings while the
backup job is running. If changed, the
connection will temporarily terminate
and the backup job will fail.
Reduce the number of backup
destination files or disable any other
functions running at the same time.
Do not change the settings while the
backup job is running. If changed, the
connection will temporarily terminate
and the backup job will fail.
128
Log Example
rsync error: error
starting client-server
protocol (code 5) at
main.c(1504)
@ERROR: auth failed on
module
@ERROR: permission
denied
rsync error: error in
socket IO (code 10)
at clientserver.c(128)
[sender=3.1.0pre1]
rsync error: error
in file IO (code 11)
at receiver.c(389)
[receiver=3.1.0]
rsync: write failed on
"filename": File too
large (27)
rsync error: error in
rsync protocol data
stream (code 12) at
io.c(515)
ERROR: out of memory
in flist_expand
rsync error: error
in IPC code (code
14) at main.c(655)
[receiver=2.6.8]
rsync: fork failed in do_
recv: Cannot allocate
memory (12)
rsync error: error
allocating core
memory buffers
(code 22) at util.c(120)
[sender=2.6.8]
rsync error: received
SIGINT, SIGTERM, or
SIGHUP (code 20) at
rsync.c(242)