Table of Contents
Advertisement
Chapter 13 Appendix
LCD Message
I18
Rebuilding
Array x...
I19 Rewriting
Array x...
I20
Formatting
Drive x...
I21 Checking
Drive x...
I22 Rewriting
Drive x...
I23
Initializing
Settings...
I25 Updating
Firmware...
I26
Initializing
Settings...
I27 Checking
USB Drive
x...
I28
Formatting
USB Drive
x...
I31 Push Func
to Use New
Drive x
I32 New Drive
x Detected
I37
Recovering
System...
I38 Recovery
Finished
I40 All Data
Will Be
Deleted
Description
Recovering the RAID array.
Note: Transfer speeds are slower during
the rebuilding process.
Rewriting drives in the TeraStation with 0s.
Formatting the drive.
Checking the drive.
Rewriting drives in the TeraStation with 0s.
The initialization process has been started
by using the reset button and settings are
being initialized.
Updating the TeraStation firmware.
The initialization process has been started
by using Settings and all settings are being
initialized.
Checking the USB drive.
Formatting the USB drive.
Appears before the function button is
pressed in order to use a newly-inserted
drive.
Appears after replacing the drive when the
RAID array needs to be rebuilt in Settings
or formatting is necessary.
The initialization process has been started
by using the USB initialization drive and
settings are being initialized.
Settings initialization is finished.
Beginning settings initialization. All data
on the drive in slot 1 will be deleted.
Corrective Action
-
-
-
-
-
-
Do not turn off the TeraStation's power.
-
-
-
Press the function button. If the RAID array
enters degraded mode, the array will be
rebuilt using the new drive. Otherwise, the
new drive will be set as a hot spare.
To use a drive as normal instead of a
hot spare drive, refer to the appropriate
"Drive Replacement for Hot Spare" section
in chapter 11 that corresponds to your
TeraStation model.
From Settings, either recover the RAID
array or format the drive.
-
-
-
285
Advertisement
Table of Contents
