Table of Contents
Advertisement
Chapter 5 Backup
4
Under "LAN Protocol Support", select the "Backup" checkbox on the Basic tab.
5
Click OK and proceed to the next step to create a backup device access key.
6
Enter the desired characters into the backup device access key field and click OK.
Note: You may leave this field blank if you do not want a backup device access key, but for security reasons
we highly recommend entering one for the shared folder. If a backup device access key is configured for the
shared folder, that folder will not show up as the replication destination when configuring a replication job on
another Buffalo NAS device unless it's entered. You may create multiple folders using different backup device
access keys for backup and replication, but only one access key can be used on the TeraStation. Folders that
are configured with a different access key cannot be used.
7
The process is complete once you close the confirmation window that appears.
Note: If you want to replicate to a Buffalo NAS device on another network, follow the procedure below to add the
Buffalo NAS device so it can be used as a replication destination.
(1) Create a new replication job by referring to the
(2) On the screen that allows you to select a shared folder, click List of Servers.
(3) Click Add; select the "Add Buffalo NAS device" option, enter the IP address or hostname of the destination
Buffalo NAS device, then click OK.
(4) Click Close.
(5) Click Refresh and make sure the desired Buffalo NAS device has been added to the list.
"Configuring a Replication Job"
132
section below.
Advertisement
Table of Contents
