Buffalo TeraStation 5020 User Manual page 15

Chapter 2 Getting Started
11
Drive Lock
Open the front panel with the key to replace drives or access the init button.
12
Reset Button
Press and hold down this button with something pointed to initialize the TeraStation's admin username and
password, two-factor authentication settings, IP settings, SSL, and service port restriction settings to their
factory default values. The effects of this button can be changed in Settings.
During initialization, the TeraStation will beep and the
initialization finishes, the
13
Drive Status LEDs
Normally, these LEDs blink green when drives are accessed. If a drive fails, its LED will turn red.
14
Fan
Spins to prevent overheating inside. Do not block the fan.
15
USB Port
Compatible USB drives, USB memory devices, and USB UPS devices can be connected. USB hubs are not
supported.
For the TS5820DN TeraStation model, the USB port in front is covered by a protector. Remove it before use.
16
LAN Port 1 (1GbE)
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
17
LAN Port 2 (1GbE)
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
18
LAN Port 3 (10GbE)
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 10 Gbps
if using the included Ethernet or category 6A cable.
Note: To communicate at up to 10 Gbps, all connected network devices must be compatible with 10GbE.
19
Power Connector
Use the included power cable to connect to a UPS, surge protector, or outlet.
20
Serial Number
This sticker shows the TeraStation's serial number.
21
UID Button
Press this button to cycle the blue LED on and off.
22
Anti-Theft Security Slot
Use this slot to secure your TeraStation with a cable lock (not included).
23
Link/Act LED
Glows green when the TeraStation is connected to a network at 1000 Mbps. It blinks when the connection is
experiencing activity.
24
Link/Act LED
Glows amber when the TeraStation is connected to a network at 100 Mbps, 2.5 Gbps, or 5 Gbps. It blinks when
the connection is experiencing activity.
I23
message will disappear.
I23
message will appear as a notification. When
14