Saving And Applying Settings; Saving Settings - Buffalo TeraStation TS4800D User Manual

3
Click to the right of "SNMP".
4
Click Edit.
5
Configure the desired settings, then click OK.

Saving and Applying Settings

The TeraStation's settings can be saved to a USB memory device and restored to another TeraStation. Use this function to
back up and copy settings to a new TeraStation.
Make a note of the hard drive configuration (number of hard drives, RAID, LVM, etc.) of the TeraStation where the
settings were saved. Make sure that any TeraStation that you apply these settings to has exactly the same hard drive
configuration before you apply the settings. If the drive configuration is different, you may get unexpected results.
The following settings are not saved or restored:
Category
File sharing
USB drive and memory cartridge shared folder
information
All settings in "Drives"
Network
Backup
Management

Saving Settings

1
Insert a USB memory device into a USB port on the TeraStation.
Notes:
• Use a USB 2.0 port. If your TeraStation has both USB 3.0 and USB 2.0 ports, make sure that you use one of the USB
2.0 ports.
• The USB memory device should have a capacity of at least 1 GB.
• Any data stored on the USB memory device will be deleted.
2
In Settings, click Management.
Settings
All settings in "RAID" - "Options" - "RAID Array Settings"
All settings in "LVM"
All settings in "iSCSI"
USB drive and memory cartridge information
All settings in "IP Address"
All settings in "Port Trunking"
All settings in "Failover"
All settings in "Name"
All settings in "UPS Sync"
All settings in "SSL"
Display language in Settings
125