Tighten the capture nuts.
Step 7.
Install the blank panel into the frame opposite the system, or install a second system.
Step 8.
Tighten the capture nuts.
Step 9.
Tighten all ten screws to 9.2 Nm or 81.5 pound inches.
Step 10.
2.4.3
Table Top
This section is relevant to short depth systems that allow such form of installation only.
Included in the box is a bag with 4 rubber stick-on feet for table top installation.
Table Top Installation
Peel and stick the four rubber bumpers into the bottom of the system. Place them in the round
Step 1.
circles.
Figure 16: Insert System into Frame
Mellanox Technologies
23