Scanning Active Time - Datalogic PowerScan Series Product Reference Manual

REFERENCES

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON state once the
state is entered. The range for this setting is from 1 to 255 seconds in 1-second incre-
ments.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the result with leading zeroes to yield three digits. For example: 0 = 000, 5 =
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
4. Scan the bar code: SELECT SCANNING ACTIVE TIME SETTING on
5. Scan the appropriate three digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the table below for examples of how to set this fea-
ture.
Table 21 Scanning Active Time Setting Examples
STEP
1 Desired Setting
2 Pad leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT SCANNING ACTIVE TIME SETTING
Scan three characters from
5
Appendix G
6 Scan ENTER/EXIT PROGRAMMING MODE
334
POWERSCAN™ PD/PM/PBT9600
005, 20 = 020, etc.
Mode.
the duration which was determined in the steps above. You will hear a two-beep
indication after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
ACTION EXAMPLES
90 Sec.
1 Second
(1.5 min.)
001 090
'0', '0' and '1' '0', '9' and '0' '1', '8' and '0' '2', '5' and '5'
.
page 110
, that represent
Appendix G
180 Sec.
255 Seconds
(3 min.)
(4.25 min.)
180 255