Symbology-Specific Parameters - Datalogic PowerScan Series Product Reference Manual

CONFIGURATION WITH BAR CODES

Symbology-specific parameters:

1D Symbologies, starting on page 130
options for all symbologies and provides the programming bar codes necessary for con-
figuring these features.
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of each pro-
2. Scan the bar code to set the desired programming feature. You may need to cover
3. If additional input parameters are needed, go to
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-
For more detailed descriptions, programming information and examples for setting
selected configuration items, see
42
POWERSCAN™ PD/PM/PBT9600
NOTE: You must first enable your reader to read bar codes in order to use
this section. If you have not done this, go to Setup, starting on page 7 and
complete the appropriate procedure.
gramming page, when applicable.
unused bar codes on the page, and possibly the facing page, to ensure that the
reader reads only the bar code you intend to scan.
priate characters from the keypad.
NOTE: Additional information about many features can be found in the
References, starting on page 314 .
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again from the
beginning.
MING bar code to exit Programming Mode.
and
2D Symbologies, starting on page 215
Appendix G
References, starting on page 314
define
, and scan the appro-
.