Scanner Character Terminator - Datalogic PowerScan Series Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

Scanner Character Terminator

By default CM968x considers a Label transmitted by the scanner 'CR' terminated.
If this format is not possible, for instance when "CR" is present in the middle of the
labels, it is possible to change the terminator with one or more different characters.
Scanner Character Terminator
$CETTE
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
94
POWERSCAN™ PD/PM/PBT9600
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by 20 digits (in hex) from the Alphanumeric
characters in Appendix G, Keypad
desired character(s).
If less than the expected string of 20 characters is
selected, scan the ENTER/ EXIT bar code to termi-
nate the string. Exit programming mode by scanning
the ENTER/EXIT barcode again.

0D00...
ETHERNET INTERFACE
representing your
CANCEL