Dhcp; Static Ip Address - Datalogic PowerScan Series Product Reference Manual

DHCP

When DHCP is Enabled, the CM968x dynamically obtains an Internet Protocol (IP)
address from a Dynamic Host Configuration Protocol (DHCP) server.
Otherwise, static IP address are used.
$CETDC00
DHCP = Enable

Static IP Address

This feature sets a Static IP address for the CM968x. An IP address is a 32-bit number
that is noted by using four numbers from 0 through 255, separated by periods. For
example: 192.168.1.100.
To add the Cradle to an existing LAN you must specify a unique IP address that is not
used elsewhere in the network.
Static IP Address
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
$CETIP

C0A8BB1F = (hex) 192.168.187.031
ENTER/EXIT PROGRAMMING MODE

DHCP = Disable
$CETDC01
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by 8 digits (in hex) from the Alphanumeric
characters in Appendix G, Keypad
desired character(s). End by scanning the ENTER/
EXIT bar code.
CANCEL
representing your
PRODUCT REFERENCE GUIDE
87