Appendix E. Host Commands Characters - Datalogic PowerScan Series Product Reference Manual

APPENDIX E
HOST COMMANDS CHARACTERS
The scanner shall recognize the following host commands when transmitted to the
scanner over the standard RS-232 host port (RS232, RS232-WN, RS232-OPOS) or the
Aux port or USB-COM port.
CHARACTER
'i' (0x69)
'h' (0x68)
's' (0x73)
<SOH> (0x01)
<BEL> (0x07)
'R'
'B'
'F'
'E'
'D'
't'
'T'
'X'
'S'...<CR>
'x'...<CR>
34<CR>
01<CR>
'd'
a. Can be configured.
b. The reply of these commands are in the format: {SOH}{STX}...{ETX}{EOT}
Device Information (Used by OPOS/JPOS)
Device health (Used by OPOS/JPOS)
Device statistics (Used by OPOS/JPOS)
Beep and Viber good read tone with no regard for configuration control
Beep on Bell (see Beep on Bell configuration item)
Reset Scanner
Beep and Viber good read tone
Not on File (Disable scanner and sound not on file Beep)
b
Scanner Enable
b
Scanner Disable
Reserved
SW Trigger pull. Simulate a trigger pull
SW Trigger released. Simulate a trigger pull.
Reserved
Reserved for Image Capture protocol
Beep Low Tone
Beep High Tone
Docking State (Mobile only)
COMMAND
a
a
a
a
PRODUCT REFERENCE GUIDE
381