Chapter 2. Setup; Unpacking; Setting Up The Powerscan™ Pd9600 Reader; Connecting The Host Interface - Datalogic PowerScan Series Product Reference Manual

CHAPTER 2
SETUP

UNPACKING

Check carefully to ensure the reader and any cables or accessories ordered are present
and undamaged. If any damage occurred during shipment, contact "
on page xvi
SETTING UP THE POWERSCAN™ PD9600 READER
Follow the steps below to connect and get your reader up and communicating with its
host.
1. Connect the Cable to the reader and the Host (see
2. Configure the Interface (see
3. Configure the Reader starting
Connect the PowerScan™ by plugging directly into the host device as shown. The power
can also be supplied through an external power supply via the Interface Cable supplied
with a power jack.

CONNECTING THE HOST INTERFACE

Connecting the Cable

The reader kit you ordered to match your interface should provide a compatible cable
for your installation. If this is not so, contact "
Follow the steps below to connect the cable to the reader.
1. Use a screwdriver to open the handle.
.
page 7
).
page 36
(optional, as needed).
page 41
Technical Support" on page xvi
Technical Support"
).
.
PRODUCT REFERENCE GUIDE
7