Logger Socket Port; Data Flow Control Selection - Datalogic PowerScan Series Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

LOGGER Socket Port

This parameter will allow the identification of a network service on an IP network (the
Internet). It is a mapping to the underlying TCP-IP socket port number used for monitor-
ing data transfer. This Socket works also for industrial protocol Profinet or Ethernet IP.
Logger Socket Port
$CETLP
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

DATA Flow Control Selection

The Datalogic Flow Control Mode is a powerful way to manage and optimize the com-
munication with the Fieldbus Master. By enabling the FCM a few bytes of the exchange
areas are reserved for driver operations and the rest are used by the application layer.
For more details see FBC9080 Fieldbus Converter Software Integration Guide.
$CETDO00\r
Flow Control Enable
$CETDO02\r
Flow control and consistency enable
92
POWERSCAN™ PD/PM/PBT9600
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by 5 digits from the Alphanumeric
in Appendix G, Keypad
character(s).
Exit programming mode by scanning the ENTER/
EXIT barcode again.

52000

Flow Control Disable
Consistency Enable
ETHERNET INTERFACE
characters
representing your desired
CANCEL
$CETDO01\r
$CETDO03\r