Table of Contents
Advertisement
ENTER/EXIT PROGRAMMING MODE
BARCODE/KEY DIFFERENT DATA FORMAT
If this parameter is enabled, barcode and keyboard entered data can be formatted sepa-
rately. More specifically: if this parameter is disabled, barcode and keyboard data will
share the same Header and Terminator defined using "Set Barcode Header" and "Set
Barcode Terminator" below. If this parameter is enabled, keyboard entered data are
treated differently, as their format must be programmed through the parameters Set
String Header, Set String Terminator, Set Key Sequence Header and Set Key Sequence
Terminator.
$CPWDF01
Set Barcode Header
Sets the header for barcode and keyboard composed strings.
Set barcode header
$CPWBH
Set Barcode Terminator
Sets the terminator for barcode and keyboard composed strings.
Set barcode terminator
$CPWBT
272
POWERSCAN™ PD/PM/PBT9600
Disable
DISPLAY AND KEYBOARD FEATURES
$CPWDF00
Enable
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by 32 digits from the Alphanumeric
characters in
Appendix G,
be the hexadecimal ASCII representation of the
desired characters.
If less than the expected string of 16 characters are
selected, scan the ENTER/EXIT bar code to terminate
the string. If the first 2 digits are 0, the feature is dis-
abled. End by scanning the ENTER/EXIT bar code
again.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by 32 digits from the Alphanumeric
characters in
Appendix G,
be the hexadecimal ASCII representation of the
desired characters.
If less than the expected string of 16 characters are
selected, scan the ENTER/EXIT bar code to terminate
the string. If the first 2 digits are 0, the feature is dis-
abled. End by scanning the ENTER/EXIT bar code
again.
Keypad. The digits must
Keypad. The digits must
Advertisement
Table of Contents
