Digit Address Stamping; Assign Unique Address To The Gun - Datalogic PowerScan Series Product Reference Manual

FEATURES FOR STAR MODELS ONLY

4 Digit Address Stamping

When address stamping is enabled, by default the device uses a 12 hex digit address.
es: 0000002139AE<Message>
With the following setting It is possible to reduce the address size at 4 digit in order to
be compatible with host working with this format. The address is not build in into the
scanner but must be configured manually by label programming during the installation.
It is responsibility of the installer to avoid duplicated address working with the same
base.
•
•
•
Enable Address Stamping and eventually address delimiter (See "Source Radio Address
Transmission" on page 292.)
$CRF4E00
4 Digit Address Stamping = Enable

Assign Unique Address to the Gun

Assign unique address to the gun as a character string in the range 0000 to 1999.
Assign Unique Address
$CRF4H
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
This feature affects only the message format between Cradle and Host. Doesn't
impact the Radio protocol or procedure to link base and gun.
In case "Ack from host is configured, the return message must have the same 4
digit address as a prefix.
This feature is not recommended for new installation.
Example: 1234 = 31323334
ENTER/EXIT PROGRAMMING MODE

4 Digit Address Stamping = Disable
$CRF4E01
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by 4 couples of digits (in hex)
from the Alphanumeric characters in
Keypad representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
CANCEL
PRODUCT REFERENCE GUIDE
Appendix G,
309