Conference Table - BOMBARDIER Challenger 650 Handbook

Conference Table

WARNING: During taxi, takeoff, and landing, conference table leaves must be folded closed and attached with
straps, and the table must be stowed at its lowest position. Failure to observe this warning may
result in injury to cabin occupants.
A manually operated conference table
table includes two fold-out leaves, a center leaf, and four drink holders. The drink holders are on the bottom side of the
fold-out leaves. The table acts as a work space when raised. Call/lighting switch panels are located on the inboard end of
the table. A height control handle is used to change the table top position.
Raise/Lower the Conference Table
To raise and deploy the conference table:
1. Detach the Velcro restraining strap from the forward and aft table leaves.
2. Hold the release lever while allowing the table to rise to the desired height.
Note: When stowed, the manual conference table is under hydraulic pressure. To prevent the table from rising too rapidly when the
release lever is operated, apply moderate downward hand pressure on the table top until it reaches the desired height.
3. Release the control lever to stop the table.
4. Unfold the forward and aft leaves.
(Figure 30) is installed on the left side between double seats 05, 10, 08, and 11. The
6076 (Rev. 2) Dec 12 2016
CABIN FURNISHINGS
53