Run Led Fast Flashes; Power Module Failures; Power Led Is Off - H3C SR6600-X Series Manual
Hide thumbs
Also See for SR6600-X Series:
- Configuration manual (282 pages) ,
- Command reference manual (265 pages) ,
- Manual (80 pages)
Table of Contents
Advertisement
3.
Verify that the system power is sufficient. If the system power is insufficient, the system displays
the following information:
%Apr 26 16:46:32:169 2012 H3C DRVMSG/1/InSufficientPwr:
No sufficient power, failed to power on slot 3.
4.
Execute the
Slot3:
The Board is present, state is unknown
5.
If the problem persists, contact H3C Support.
RUN LED fast flashes
Symptom
20 minutes after the router is powered on or the LPU is inserted into the router, the RUN LED for the
LPU still fast flashes at 8 Hz. If you enter the
following output:
<H3C> display device
System-mode(Current/After Reboot): Normal/Normal
Slot No.
--------------------------------------------------------
0
1
2
3
4
5
6
7
8
9
The output shows that LPUs in Slots 8 and 9 have failed.
Solution
To resolve the problem, contact H3C Support.
Power module failures
Power LED is off
Symptom
The router cannot be powered on and the power LED on the front panel is off.
Solution
To resolve the problem::
1.
Verify that the power switch is turned on.
2.
Verify that the power cords of the router are firmly connected.
3.
Verify that the switch of the power source is turned on.
4.
Verify that the power cord is not damaged.
display version
Board type
Status
N/A
Absent
N/A
Absent
N/A
Absent
FIP-210
Normal
RSE-X2
Normal
N/A
Absent
N/A
Absent
N/A
Absent
FIP-210
Startup
FIP-600
Startup
command to verify that the LPU is in position:
display device
Primary
SubSlots
N/A
N/A
N/A
N/A
N/A
N/A
N/A
2
Master
0
N/A
N/A
N/A
N/A
N/A
N/A
N/A
2
N/A
2
71
command, the system displays the
Advertisement
Table of Contents
