Connecting The Power Cord; Connecting An Ac Power Cord - H3C SR6600-X Series Manual

Figure2-20 Installing a surge protector
(1) Grounding cable
The performance of the surge protector might be affected in the following cases:
•
The surge protector is installed in reverse direction. Connect the IN end to the outdoor network
cable and the OUT end to the network port on the router.
•
The surge protector is not well grounded. After the connection, use the multimeter to confirm
that the ground wire for the protector is as short as possible to ensure its good contact with the
grounding screw of the router.
•
The installed surge protectors are not sufficient. If the router has more than one cable
connected with other devices through cables outdoor, install a surge protector for each cable.

Connecting the power cord

Connecting an AC power cord

1. Make sure the router is well grounded, and the power switch on the router is in the OFF
position.
2. Connect one end of the AC power cord to the AC receptacle on the router, and the other end to
the AC power source.
3. Use cable ties to secure the power cord to the rack post.
1
2
(2) Surge protector
24