Msr3600-51-G-Dp; Led Description - H3C MSR3600 Manual

MSR3600-51-G-DP

Figure1-95 MSR3600-51-G-DP LEDs
1
(1) Gigabit Ethernet copper port LEDs (GE5 to GE52)
(3) SFP+ port LEDs (SFP+53 and SFP+54)
(5) Power supply LED (PWR2)
(7) System status LED (SYS)

LED description

IMPORTANT:
• The SFP28 ports on the MSR3600-28-X1, MSR3600-28-XS, or MSR3600-28-X1-DP router and
SFP52 ports on the MSR3600-51-X1 or MSR3600-51-X1-DP router can operate only at 1000
Mbps.
• The SFP+16 and SFP+17 ports on the MSR3620-X1 or MSR3620-X1-XS router does not
support operating at 1000 Mbps.
• The SFP+9 to SFP+11 ports on the MSR3640-X1 or MSR3640-XS router does not support
operating at 1000 Mbps.
• The SFP+10 port on the MSR3610E-X1 or MSR3610E-X1-DP router does not support operating
at 1000 Mbps.
Table1-1 LED description
LED
SYS
SYS (applicable to
MSR3610-X1/MSR3
State
Flashing green (8 Hz)
Steady green
Flashing green (1 Hz)
Flashing yellow (1 Hz)
Flashing yellow (8 Hz)
Steady yellow
Off
Flashing green (8 Hz)
Flashing yellow (8 Hz)
Flashing green (1 Hz)
1-42
7 6 5
(2) Gigabit Ethernet copper port LED (GE0)
(4) Gigabit Ethernet copper port LEDs (GE1 to
GE4)
(6) Power supply LED (PWR1)
Description
The BootWare is running.
The SDRAM is performing self-test.
Comware has started with the configuration file and the
router has booted up.
The DDR3 SDRAM has failed the self-test.
The extended segment does not exist.
The boot image does not exist.
No power input, or exceptions have occurred.
USB-based automatic configuration has succeeded.
USB-based automatic configuration has failed.
Comware has started with the configuration file and the
device has booted up.
2
4 3