To install an SFE-X1:
1.
Face the front of the router and locate the slot.
2.
Loosen the captive screws on the filler panel in the slot, and then remove the filler panel.
Keep the removed filler panel for future use.
3.
Insert the SFE-X1 slowly along the slide rails until positioning pins on the backplane are seated
in the positioning holes, and then push the ejector levers inward to lock the SFE-X1 in position.
4.
Fasten the captive screws on the two sides of the SFE-X1.
For the SFE-X1 LED description, see H3C SR6604-X/SR6608-X/SR6616-X Routers Hardware
Information and Specifications.
Figure2-10 Installing an SFE-X1
Installing an LPU
CAUTION:
The RUN LED flashes fast when the FIP is starting up. To avoid hardware damage, do not install or
remove a HIM/MIM/MIC during this period.
Slot 3 of the SR6604-X/SR6608-X and Slot 7 of the SR6616-X are not provided with filler panels.
Before the installation, make sure the ejector levers of the LPU are outwards.
The procedures for installing LPUs are similar. This section uses a FIP-210 as an example.
16