Installing A Him/Mim/Mic - H3C SR6600-X Series Manual

To install a FIP-210:
1. Face the front of the router and locate the slot to be used.
2. Loosen the captive screws on the filler panel in the slot and then remove the filler panel.
Keep the removed filler panel for future use.
Skip this step if you install the FIP-210 to Slot 3 of the SR6604-X/SR6608-X, or Slot 7 of the
SR6616-X.
3. Gently push the FIP-210 into the slot along the slide rails until positioning pins on the backplane
are seated in the positioning holes, and then push the ejector levers inward to lock the FIP-210
in position.
4. Fasten the captive screws on the two sides of the FIP-210.
For more information about the FIP LED description, see H3C SR6604-X/SR6608-X/SR6616-X
Routers Hardware Information and Specifications.
Figure2-11 Inserting a FIP

Installing a HIM/MIM/MIC

CAUTION:
HIMs, MIMs, and MICs support hot swapping. Before removing a HIM/MIM/MIC, first execute the
remove slot number
The procedures for installing HIMs, MIMs, and MICs are the same.
To install a HIM/MIM/MIC:
1. Face the front of the router and locate the slot to install the HIM/MIM/MIC on the FIP module.
2. Loosen the captive screws on the filler panel, and then remove the filler panel.
Keep the removed filler panel for future use.
3. Use even pressure to push the HIM/MIM/MIC slowly along the slide rails into the slot, and then
close the ejector levers.
Install a HIM/MIM with the components upward and install an MIC with the components
downward.
4. Fasten the captive screws on the HIM/MIM/MIC.
5. Observe the LED for the slot on the router front panel to verify that the HIM/MIM/MIC is installed
correctly.
command to stop the HIM/MIM/MIC from operating.
17