Replacing A Fan Tray For An Sr6616-X Router; Replacing An Air Filter; Replacing An Air Filter For An Sr6604-X/Sr6608-X Router - H3C SR6600-X Series Manual

Replacing a fan tray for an SR6616-X router

1. Face the front of the router.
2. Press the fan tray release button with the thumb, slightly pull the fan tray away from the chassis,
and slowly pull the fan tray out along the slide rails when fans stop spinning.
3. Holding the front part of the fan tray with one hand, pressing down the release button with the
thumb, and supporting the bottom of the fan tray with the other hand, push the fan tray into the
slot along the slide rails until the fan tray makes complete contact with the backplane.
Figure5-9 Pulling out the fan tray

Replacing an air filter

IMPORTANT:
You can clean the air filter with water, but wait until it is completely dry before installing it again.

Replacing an air filter for an SR6604-X/SR6608-X router

1. Face the left side of the router.
2. Completely loosen the captive screws of the air filter.
56