Table of Contents
Advertisement
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on page
4. If an optional expansion unit is installed, remove the expansion unit (see
5. Locate the USB Flash key on the system board (see "Blade server connectors"
6. Using your fingers, pull the USB Flash key out of the connector.
7. If you are instructed to return the USB Flash key, follow all packaging
Installing a USB Flash key
Use these instructions to install a USB Flash key in the blade server.
The following illustration shows the installation of the USB Flash key.
To install a USB module, complete the following steps:
1. If a CIOv expansion card is installed, remove the expansion card (see
2. Locate the USB connector on the blade server (see "Blade server connectors" on
3. Touch the static-protective package that contains the USB Flash key to any
4. Orient the connector on the USB Flash key with the USB connector on the
5. Use your fingers to push the USB Flash key into the USB connector on the
6. If a CIOv expansion card was removed during the install process, install the
70
BladeCenter HS23E Type 8038 and 8039: Problem Determination and Service Guide
page 47.
the blade server from the BladeCenter unit" on page 49).
52).
"Removing an optional expansion unit" on page 79).
on page 13).
instructions, and use any packaging materials for shipping that are supplied to
you.
"Removing a CIOv-form-factor expansion card" on page 71).
page 13).
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component in the rack in which you are installing
the USB module for at least two seconds; then, remove the USB module from
its package.
blade server.
blade server.
expansion card (see "Installing a CIOv-form-factor expansion card" on page
73).
Advertisement
Table of Contents
