Lenovo BladeCenter HS23E Problem Determination And Service Manual page 34

20
BladeCenter HS23E Type 8038 and 8039: Problem Determination and Service Guide
- BBS Boot
Select this choice to enable or disable legacy boot in BBS manner. The
default is Enable.
- Non-Planar PXE
Select this choice to enable or disable non-planar PXE for legacy mode. The
default is Enable.
– System Security
Select this choice to view or change the security options for Trusted Platform
Module (TPM).
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module II (IMM2).
- Commands on USB Interface Preference
Select this choice to specify whether the Ethernet over USB interface is
enabled or disabled.
Note: This option is primarily for older operating systems that have
problems with USB communications device class (CDC) Ethernet interfaces.
Disabling this option will cause the following issues:
v Online update packages will not work.
v Updates that use Bootable Media Creator (BoMC) will not work because
BoMC uses the LAN over USB interface.
v You must install the IPMI device driver to use ASU to change the IMM2
or UEFI configuration.
v You cannot set the IMM2 OS Loader watchdog.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM2 MAC address, the current IMM2 IP address, and host name.
- Restore IMM to Defaults
Select this choice to restore the IMM2 to the default settings. The IMM2
controller restarts after you restore the settings.
- Restart IMM
Select this choice to restart the IMM2 controller.
– Recovery
Select this choice to view or change the system recovery parameters.
- POST Attempts
Select this choice to view or change the number of attempts to POST.
v POST Attempts Limit
Select this choice to view or change the Nx boot failure parameters.
- System Recovery
Select this choice to view or change system recovery settings.
v POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
v POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value
in minutes.
v Reboot System on NMI