Removing A Blade Handle - Lenovo BladeCenter HS23E Problem Determination And Service Manual

1. If the control panel was removed, install it (see "Installing the control panel" on
2. Orient the bezel with the front of the blade server, aligning the screw holes on
3. Use your hand to keep the bezel assembly tight against the blade server; then,
4. Use a screwdriver to install the four screws that secure the bezel assembly to
5. Orient the blade server so that the bottom of the blade server is down.
6. Install the optional expansion unit, if you removed one from the blade server
7. Install the cover onto the blade server (see "Installing the blade server cover"
8. Install the blade server into the BladeCenter unit (see "Installing the blade

Removing a blade handle

Use these instructions to remove a blade handle.
The following illustration shows how to remove a blade handle.
56
BladeCenter HS23E Type 8038 and 8039: Problem Determination and Service Guide
page 78).
the bezel with the holes on the blade server.
rotate the blade server so that the bottom is now facing up.
the blade server. It is recommended to use the same screws that were removed
when the bezel assembly was removed.
(see "Installing an optional expansion unit" on page 80 for instructions).
on page 53).
server in a BladeCenter unit" on page 50).