Table of Contents
Advertisement
7. Orient the battery so that the positive (+) side faces in towards the center of
the blade server.
8. Tilt the battery so that you can insert it into the bottom of the socket.
9. As you slide the battery into place, press the top of the battery into the socket.
10. If you removed a plastic cover from the battery holder, use your fingers to
install the battery cover on top of the battery connector.
11. Install the optional expansion unit, if you removed one from the blade server
to replace the battery (see "Installing an optional expansion unit" on page 80
for instructions).
12. Install the cover onto the blade server (see "Installing the blade server cover"
on page 53).
13. Install the blade server into the BladeCenter unit (see "Installing the blade
server in a BladeCenter unit" on page 50).
14. Turn on the blade server, start the Setup utility, and reset the configuration
(see "Using the Setup utility" on page 18 for instructions).
Removing a hot-swap storage drive
Use this information to remove a hot-swap storage drive.
The blade server has two hot-swap storage bays for installing or removing
hot-swap storage devices. To remove a hot-swap hard disk drive or drive filler,
complete the following steps.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
page 47.
2. If possible, save the data on your drive, especially if it is part of a RAID array,
before you remove it from the blade server.
3. Press the release latch (orange) on the storage drive to release the drive handle.
Chapter 5. Removing and replacing blade server components
63
Advertisement
Table of Contents
