Table of Contents
Advertisement
Installing the control panel
Use these instructions to install the control panel in the blade server.
The blade server has a control panel that provides controls and information LEDs
for the blade server (see "Blade server controls and LEDs" on page 9). The
following illustration shows how to install the control panel.
To install the control panel, complete the following steps:
1. Locate the control-panel connector on the blade server (see "Blade server
2. Touch the static-protective package that contains the control panel to any
3. Orient the control panel so the cable aligns with the control-panel connector
4. Use your fingers to install the control-panel cable into the control-panel
5. Install the bezel assembly (see "Installing the bezel assembly" on page 55).
6. Install the optional expansion unit, if you removed one from the blade server to
7. Install the cover onto the blade server (see "Installing the blade server cover"
8. Install the blade server into the BladeCenter unit (see "Installing the blade
78
BladeCenter HS23E Type 8038 and 8039: Problem Determination and Service Guide
connectors" on page 13).
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component in the rack in which you are installing
the control panel for at least two seconds; then, remove the USB module from
its package.
and the control panel is positioned at the front of the blade server.
connector on the blade server.
replace the battery (see "Installing an optional expansion unit" on page 80 for
instructions).
on page 53).
server in a BladeCenter unit" on page 50).
Advertisement
Table of Contents
