Table of Contents
Advertisement
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
page 47.
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
the blade server from the BladeCenter unit" on page 49 for instructions).
3. Carefully lay the blade server on a flat, static-protective surface, with the cover
side down.
4. Open the blade server cover (see "Removing the blade server cover" on page
52 for instructions).
5. Remove heat sink 1 (see "Removing a microprocessor and heat sink" on page
81 for instructions).
6. Sightly disengage the air baffle stickers from the system board.
7. Pull the air baffle up to remove it out of the blade server.
8. If you are instructed to return the air baffle, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Installing the air baffle
Use this information to install a air baffle in the blade server.
Notes:
1. The following illustration shows how to install the air baffle in a blade server.
2. The illustrations in this document might differ slightly from your hardware.
To install the air baffle, complete the following steps.
Chapter 5. Removing and replacing blade server components
59
Advertisement
Table of Contents
