Lenovo BladeCenter HS23E Problem Determination And Service Manual page 177

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 4, "Parts listing," on page 41 to determine which components are consumable, structural, or CRU
parts.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
Error Code Event ID
0x806f052b 806f052b-2101ffff
0x806f0607 806f0607-0301ffff
806f0607-0302ffff
0x806f0607 806f0607-2584ffff
Type Error Message
Error Invalid or
Unsupported
firmware or
software was
detected on system
(IMM2 FW
Failover).
Error Processor X (CPU
X) SM BIOS
uncorrectable CPU
complex error
[Note: X=1,2]
Error Processor (All
CPUs) SM BIOS
uncorrectable CPU
complex error.
Action
Make sure you have the latest system
firmware (see "Updating firmware and
device drivers" on page 31).
1. Verify that you have the latest system
firmware (see "Updating firmware and
device drivers" on page 31).
2. (Trained technician only) If the error still
occurs, replace microprocessor X (see
"Removing a microprocessor and heat
sink" on page 81 and "Installing a
microprocessor and heat sink" on page
84).
3. (Trained technician only) If the error
continues, replace the system-board
assembly (see "Removing the
system-board assembly" on page 90 and
"Installing the system-board assembly"
on page 91).
1. Verify that you have the latest system
firmware (see "Updating firmware and
device drivers" on page 31).
2. Clear the CMOS data by removing the
system battery for 30 seconds (see
"Removing the battery" on page 61 and
"Installing the battery" on page 62).
3. (Trained technician only) If the error still
occurs, replace the microprocessors one at
a time (see "Removing a microprocessor
and heat sink" on page 81 and "Installing
a microprocessor and heat sink" on page
84).
4. (Trained technician only) If the error
continues, replace the system-board
assembly (see "Removing the
system-board assembly" on page 90 and
"Installing the system-board assembly"
on page 91).
Chapter 6. Diagnostics
163